mirror of
https://github.com/qelectrotech/qelectrotech-source-mirror.git
synced 2026-10-23 15:34:12 +02:00
Kellermorph
dc92a57873
Reading where a cable lands meant going back to the drawing: the strip editor said which cable a terminal carries and which core, but never what the cable goes to. A single core (1x16) could not be followed from the terminal to its piece at all. The new Target column names it: Installation, Location and Label (BMK) of the piece the wires land on, past this strip, joined in one line -- the very three fields the strip drawing writes in the box under its cable, in the same order (RealTerminal::cableTarget()). It is worked out of the project like the Cable cells and so follows their rule: a target the drawing names is read only, for only the drawing decides it, and a cell nothing is worked out for takes an edit, so a target the drawing cannot find -- a cable landing on a piece with no Installation, Location nor Label set, a cable going to another strip -- is still worth naming by hand. The text typed in is stored in the element (RealTerminal::cableTargetInfoKey()) and kept until a cable works a target out again, and back once that cable goes, exactly like a cable designation typed by hand: the automatic value is never written, so no stale text can be left behind. The column takes the width of its own text, so a long Installation is never cut off. A text typed in is written the way the fields are shown in the column, "Installation / Location / Label", and gives one line per field: the box under the cable draws three lines without any slash in them, just like a target worked out from the project, instead of one long line carrying its separators as text. tst_terminalcableauto checks the column is empty -- and editable -- without a cable, reads "Plant 7 / Cabinet 7 / -S7" with one, goes empty -- and editable again -- when the core is removed, takes no edit while the drawing names the target, and is headed "Target"; a second case checks a target typed in by hand is taken by the cell, stored by Apply, shown again by a fresh model, set aside for the read only target of the drawing once a cable lands somewhere worth naming, and back once that cable goes; a third one the line per field. tst_cable target paints a strip whose cable ends on one field and the same strip ending on three, the second box two lines deeper than the first.